HPE AP-505H-MNT2 Installation Manual page 2

4. Screw the wall mount onto the wall box using the #6-32x1 Phillip screws, as shown in
5. Attach an active Ethernet cable to the E0 port located on the back of the access point.
Figure 2
6. Align the slots on the back of the access point against the guide posts and slots on the mount, then slide the
access point down, as shown in
Figure 3
7. (Optional) If the access point requires a DC power adapter, insert a power cable into the socket located on
the side of the access point, as shown in
2
Attach Wall Mount to Single Gang Wall Box
Figure
Secure AP-505H to Wall Mount
3.
Figure 4.
Figure 2.
AP-505H-MNT2 Mount Kit | Installation Guide