Table of Contents
Advertisement
8. Troubleshooting
8.3 During a Measurement
No.
The displayed measurement value is
abnormal.
1.
Ex)
Air Velocity:
Air Temp:
While measuring, the display screen
2.
starts blinking.
Data cannot be stored in the internal
3.
memory.
4.
The response of the reading is slow.
8.4 Analog Output
No.
1.
No output.
2.
The output value is wrong.
8.5 Digital Output
No.
1.
DEVICE ERROR is displayed.
2.
Data cannot be collected.
3.
Data is wrong.
8.6 Printer
No.
1.
The printer turns OFF while printing.
2.
Cannot take a hardcopy of the screen.
There is not print output after
3.
calculation.
www.lazodecontrol.com
Symptom
**.*
0.0
Symptom
Symptom
Symptom
Possible Cause / Solution
- If a measurement is performed out of the spec
range, "over" will be displayed on the screen.
- Probe sensor may be damaged.
- The batteries are drained.
Need new batteries.
- Setting has not been configured properly.
MEMORY YES
- Moving average deviations is selected.
FAST/SLOW key
Possible Cause / Solution
- Output only on the initial screen or when
measuring in the measurement mode?
- The screen is on hold.
- The output range is wrong.
Possible Cause / Solution
- The cable's wire connection is not correct.
- The host computer's setting is not properly
configured.
- Baud rate setting is not correct.
- Output format is not correct.
Possible Cause / Solution
- The printer's NiCd battery is drained.
- The screen may not be on hold.
Put the screen on hold.
- You may be trying to take a hardcopy while
measuring.
After the calculation, try again.
- Setting has not been configured properly.
PRINT YES
+51 960 810 089
43
Refer to
Page 11
Chapter
3
Page 9
Refer to
Page 30
Refer to
Page 34
Page 32
Page
33, 35
Refer to
Page 13
Chapter
4
Chapter
4
ventas@lazodecontrol.com
Advertisement
Table of Contents
