Program Set; How To Pre-Set Measurement Mode - Kanomax Anemomaster 6162 Operation Manual

3. Measurement Mode

3.4 Program Set

3.4.1 How to Pre-set Measurement Mode

If a measurement mode is preset, the instrument will enter the measurement standby when you turn it on.
To start a measurement, you only need to press START/STOP key.
Measurement Condition
POWER
SW-ON
Display
<Measurement Setting
Screen>
www.lazodecontrol.com
Measurement Mode
Ready for measuring
Measurement Start
Key
MENU (1) Press MENU key.
, (2) Select 5. UTILITY.
SET Then press SET key.
, (3) Select 3. PROGRAM SET.
SET Then press SET key.
,
(4) Select a measurement mode to be used.
SET Then press SET key.
(5) The cursor will move to the selected calculation mode.
Then, the measurement condition setting screen will be
displayed automatically.
(6) Configure measurement setting. Then move the cursor to 5. SET
, OK, and press SET key.
SET
The set measurement mode will be applied even when you turn
off the instrument.
If you turn the power on again, it will enter the measurement
standby mode.
Calculation Result
Procedure
OFF:
AVERAGE:
INTERVAL: Intermittent Operation Measurement
FLOW RATE: Air Flow Measurement
+51 960 810 089
No Program Set
Average Value Measurement
ventas@lazodecontrol.com
20