To Transfer Memory Data (Measurement Data Stored In Memory) - Kanomax Anemomaster 6162 Operation Manual

5. Data Output

5.2.4 To Transfer Memory Data (Measurement Data Stored in Memory)

DATA OUTPUT mode in menu screen
Display
1. RS-232C cable is not connected.
2. The wiring connection of the connector is not correct.
Referring to the example of connecting to the host computer, check the
wiring connection. (See 5.2.1 Connection Example (P.32))
3. Data cannot be retrieved.
Baud rate may not be set correctly.
Confirm the baud rate of the host computer and the instrument.
www.lazodecontrol.com
Getting Ready for Transferring Memory Data
Key
MENU (1) Press MENU key.
, (2) Select 3. DATA OUTPUT.
SET Then press SET key.
, (3) Select 3. COMPUTER.
SET Then press SET key.
Ready!
(4) When the screen shown on the left is on the display, start (RUN)
the program on your computer.
Start
Transferring
To Stop Transferring: MENU key
An error message will be displayed when...
+51 960 810 089
Internal
Memory
Procedure
Error Display
34
ventas@lazodecontrol.com