Table of Contents
Advertisement
Chapter 4: Annual Cleaning
Step
Locate where the Sweetener Line enters the side of the CGP Module and remove any
insulation blocking access to the Retaing Clip.
Note: The line entering the CGP Module from the top is the Air Vent Exhaust Tube.
4.
Remove the Sweetener Line from the CGP Module by sliding the Retaining Clip away,
and pulling the connector out of the CGP Module.
5.
Connect the QD Connector to the CGP Module and slide the Retaining Clip into place to
6.
hold it securely.
Insert the open end of the Tubing into the Bucket of Sanitizer.
7.
If the Air Vent Exhaust Tube is not plumbed into the drain, place the end in an empty
8.
bucket to catch any runoff.
VI.
Clean Product Lines
Page 19 of 28
Action
CCFS2000 Cleaning
Advertisement
Table of Contents
