Installation sequence
Siting the heat pump
Removing the transport brackets
!
Please note
If transport brackets are not removed, they
cause vibrations and excessive noise.
Remove all 4 transport brackets fully and dis-
pose of correctly.
Fig. 22
Transport locking screws
A
Fitting the back panel, side panels and kicking plates
Note
After fitting the back panel, make the hydraulic and
electrical connections. See following chapter.
28
(cont.)
!
Please note
Dust and dirt can damage the heat pump.
When installing the hydraulic and electric lines
and pipes, the side panels, top panel and front
panel should remain fitted where possible.