Panasonic AW-E860N Operating Instructions Manual page 97

$ Manual white balance setting
[ADJUSTMENT by CAMERA or multi hybrid control
panel]
Manual setting is possible in User Mode only.
1. Select the white balance mode either AWC A or AWC B
by menu.
2. Aim the camera at a large white object. Press the
ITEM/AWC switch for over 2 second.
3. Adjust the red gain/blue gain control in the PAINTING
item of Color Set sub menu of User Mode until the carrier
wave of the white portion of the video signal is at the
minimum width or the white object in the monitor screen
appears pure white. (Use an oscilloscope or a waveform
monitor for precise adjustment.)
For details on the menu operations using the multi hybrid
control panel, refer to the Operating Instructions of the multi
hybrid control panel.
[ADJUSTMENT with the RCU or ROP]
After AWC setting, adjust the R/B GAIN controller in the
same way as described in Step 3 above.
Minimize the carrier wave using
the red & blue gain controls
Waveform for white
balance set chart
$ Reset to 3200K or 5600K white balance
When the white balance setting is set to either "3200K" or
"5600K" the white balance will be automatically set to the
color temperature 3200K or 5600K, respectively.
-25-