Table of Contents
Advertisement
2.5
Mounting the Tilt Mount
The tilt mount enables the detector to be rotated up to 45 degrees (horizontal/vertical)
in all directions. The following installation instructions show how to use it to support the
detector from below (the preferred method).
To install the tilt mount:
a) Mount the tilt mount base ( Figure 11 ) to a solid structure using four suitable fixings through
the four 7mm (0.28") diameter holes. Four captive screws with spring washers are provided
in the tilt mount.
For more information & Technical support:
F-Guard UV-IR User Manual
Figure 11: Tilt Mount Base - Plate View
Figure 12: Tilt mount base – Side View
info@gastech.com
and
support@fg-detection.com
Doc. No. F110V0020.06
12
Advertisement
Table of Contents
