Installation Instructions - Realtree RTLS-502 Manual

Installation Instructions Page 1
1
1
Position bottom of stand 4-5 feet from base of tree.
3
As tree stand is being raised, the
person holding Installation Straps will
3
pull toward themselves to take up slack.
It will steady and ease the weight of
stand on the other two people. Continue
walking stand upward. Until Tree
Connection Brace is resting against
the tree.
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
W A R N I N G
DO NOT climb ladder without Stabilizer Bar or
Installation Straps installed. Serious injury or
death may occur if Stabilizer Bar and Installation
Straps are not installed.
NOTE:
Drawings are for illustration purposes only and may not depict actual product.
2
One person will stand at the base of ladder with
2
his/her foot on the bottom rung while holding
installation straps. This will prevent tree stand from
sliding. Two people will stand at opposite ends of
tree stand, facing platform and slowly walk tree
stand upward using rungs of ladder.
4
O
S
Slide the inner part of the Stabilizer Bar
into the outer part. Attach Stabilizer Bar
O to the second rung of the Middle
4
B
Ladder Section
1-M8x45mm bolt
Insert the Adjustment Knob
Stabilizer bar at the proper adjustment
point to the tree.
W A R N I N G
Stabilizer Bar and Installation Straps
MUST be secured prior to climbing
the Ladderstand. Failure to comply
may result in serious injury or death.
PRIMALVANTAGE.COM/REALTREE
MODEL: RTLS-502
15 Ft. Two-man Ladderstand
45
with
45 .
S
in the
©2019 (rev. 1/19)
9