Realtree RTLS-502 Manual page 15

Installation Instructions Page 2
5
Move base of ladder toward or
away from the tree slightly in
5
order to make Platform as
parallel to the ground as
possible.
Apply your full weight to the first
step so it settles into the ground.
8
After the ladder stand has been
secured to the tree with the
installation straps, and the
stabilizer bar has been securely
attached to the tree, continue to
8
have two people hold the ladder,
climb cautiously up to the
platform. Once you reach the
top, IMMEDIATELY ATTACH
YOUR SAFETY HARNESS TO
THE TREE. Keep the tether
strap above your head.
W A R N I N G
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
6
O
Attach Tiedown Rope
AA
6
the inner part of Stabilizer Bar
Position the Stabilizer Bar against the tree and
secure it by wrapping the rope around the back of
the tree once and tie it to itself.
9
DO NOT climb ladder without Stabilizer Bar or
Installation Straps installed. Serious injury or
death may occur if Stabilizer Bar and Installation
Straps are not installed.
DO NOT sit on seat platform until the ratchet and installation straps have been secured.
7
AA
just behind the brace of
O .
7
X
Wrap the strap of the ratchet around the
9
back of the tree once and thread through
the ratchet.
(See Details Ratchet Instructions
Below)
Stabilizer Bar and Installation Straps MUST be
secured prior to climbing the Ladderstand. Failure
to comply may result in serious injury or death.
W A R N I N G
PRIMALVANTAGE.COM/REALTREE
MODEL: RTLS-502
15 Ft. Two-man Ladderstand
T
Cross Installation Straps behind
tree. Attach to bottom ladder
section by following the
Installation Strap Instructions.
W A R N I N G
©2019 (rev. 1/19)
9