Using Your Phone with the Cordless
Module and Accessories 5330e / 5340e
Cordless handsets and cordless headsets provide you with the capability to move around
within your own office or adjacent offices while using your phone.
These cordless devices connect to your IP phone through a Mitel Cordless Module, which
attaches to the back of the phone. There are two Cordless Module types available: Digital
Enhanced Cordless Telecommunications (DECT) and Bluetooth
Module works with the Mitel DECT Cordless Handset and Mitel DECT Cordless Headset.
The Bluetooth Module works with the Mitel Bluetooth Handset and most third-party
Bluetooth headsets.
The Mitel Cordless Handsets (both DECT and Bluetooth) recharge in the handset cradle. The
Mitel Cordless Headset (DECT only) rests and recharges in a headset cradle that attaches to
the side of the phone.
The Cordless Devices Application (see page ) provides access to the configuration settings
and information screens that apply to the cordless module and accessories.
Note: Since only one module type can be attached to the phone at any given time,
you cannot, for example, use a 5310 Conference Module when a Cordless Module is
attached.
CAUTION: Attempting to remove the back plate on the phone to install a
Cordless Module before disconnecting the phone's power supply may damage
the phone. For details on installing a Cordless Module, see the appropriate
Cordless Module and Accessories Installation Guide for Mitel 5330e/5340e/5360
IP Phones included with the module and available at Mitel OnLine.
DECT Cordless Module and Accessories on 5300 Series IP Phone
®
. The DECT Cordless
Need help?
Do you have a question about the 5330e and is the answer not in the manual?
Questions and answers