Page 1
- Configure a Wi-Fi access point cluster in AP WDS repeater mode – Ubiq... Pagina 1 di 6 U BN T Sup p or t Search Ubiquiti Networks Support and Help Center airMAX Configuration Guides airMAX - Configure a Wi-Fi access point cluster in AP WDS repeater...
Page 2
airMAX - Configure a Wi-Fi access point cluster in AP WDS repeater mode – Ubiq... Pagina 2 di 6 Two or more airMAX radios can be connected in a WDS repeater topology to extend a wireless network and allow client-hotspot access at each AP. Steps 1.
Page 3
B. Choose the |Network| tab, and change only: • IP Address: 192.168.1.2 • Press [Change] Button C. Choose |Ubiquiti Logo| tab • AirMax: [ ] enable (UN-check) • Press [Change] Button, Press [Apply] Button DONE with this radio. Repeat 1-4 with the second radio, then continue below.
Page 4
Pagina 4 di 6 E. Choose the |Network| tab, and change only: • IP Address: 192.168.1.3 • Press [Change] Button F. Choose |Ubiquiti Logo| tab • airMAX: [ ] enable (UN-check) • Press [Change] Button, Press [Apply] Button DONE '''If using a Cable/DSL Modem:''' G.
Page 5
airMAX - Configure a Wi-Fi access point cluster in AP WDS repeater mode – Ubiq... Pagina 5 di 6 • Select |Wireless| Tab > Wireless Security • Security > WEP (this is the ONLY encryption available in this mode) • Preshared Key: [enter something long, but memorable to you] •...