Ubiquiti Bullet AC-IP67 Quick Start Manual
  1. Manuals
  2. Brands
  3. Ubiquiti Manuals
  4. Wireless Access Point
  5. Bullet AC-IP67
  6. Quick start manual

Ubiquiti Bullet AC-IP67 Quick Start Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Package Contents
Bullet AC IP67
Installation Requirements
Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor
wired Ethernet connections and should be grounded through the AC ground of the
PoE.
We recommend that you protect your networks from harmful outdoor environments
and destructive ESD events with industrial-grade, shielded Ethernet cable from
Ubiquiti. For more details, visit
Surge protection should be used for all outdoor installations. We recommend that
you use two Ethernet Surge Protectors, model ETH-SP, one near the Bullet and the
other at the entry point to the building. The ETH-SP will absorb power surges and
safely discharge them into the ground.
* Shown without antenna.
Hardware Overview
BulletAC-IP67 Quick Start Guide
N-Type Right Angle Adapter
ui.com/toughcable

Advertisement

Table of Contents
loading

Related Manuals for Ubiquiti Bullet AC-IP67

Summary of Contents for Ubiquiti Bullet AC-IP67

  • Page 1 PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. For more details, visit ui.com/toughcable Surge protection should be used for all outdoor installations. We recommend that you use two Ethernet Surge Protectors, model ETH-SP, one near the Bullet and the other at the entry point to the building.

  • Page 2: Hardware Installation

    BulletAC-IP67 Quick Start Guide Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. Ethernet Port This 10/100/1000 Ethernet port is used to connect the power and should be connected to the LAN and DHCP server.
  • Page 3 BulletAC-IP67 Quick Start Guide...
  • Page 4 BulletAC-IP67 Quick Start Guide...
  • Page 5 BulletAC-IP67 Quick Start Guide Note: The Bullet should be mounted vertically to reduce stress on the N-Type Connector. The N-Type Right Angle Adapter may be used as needed. Accessing airOS via Wi-Fi Verify connectivity in the airOS® Configuration Interface using the UNMS™ app or Web Portal.

  • Page 6: Web Portal

    3. Launch the app and follow the on-screen instructions. BulletAC-IP67 Quick Start Guide Web Portal 1. Connect your device’s Wi-Fi to the SSID named: <model>:<MAC Address> Note: Ensure that your Wi-Fi connection has DHCP enabled. 2. Launch your web browser and go to: http://setup.ui.com 3.

  • Page 7: Installer Compliance Responsibility

    The airOS Configuration Interface will appear, allowing you to customize your settings BulletAC-IP67 Quick Start Guide as needed. For additional details, refer to the User Guide available at ui.com/download/airmax-ac Installer Compliance Responsibility Devices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements.

  • Page 8: Safety Notices

    BulletAC-IP67 BulletAC-IP67 BulletAC-IP67 Quick Start Guide Dimensions 190 x 46 mm (7.72 x 1.81") Weight 213 g (7.51 oz) Enclosure Aluminum and Rubber Processor MIPS 74KC Memory DDR2 64MB Networking Interface (1) 10/100/1000 Ethernet Port Antenna Connector N-Type Connector Max. Power Consumption Max.

  • Page 9: Limited Warranty

    2. There are no operator serviceable parts inside this equipment. Service should be provided only BulletAC-IP67 Quick Start Guide by a qualified service technician. Limited Warranty ui.com/support/warranty The limited warranty requires the use of arbitration to resolve disputes on an individual basis, and, where applicable, specify arbitration instead of jury trials or class actions.

  • Page 10: Avis Important

    This equipment complies with radiation exposure limits set forth for an uncontrolled BulletAC-IP67 Quick Start Guide environment. This equipment should be installed and operated with minimum distance 256 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

  • Page 11: Declaration Of Conformity

    BulletAC-IP67 Quick Start Guide Declaration of Conformity Online Resources © 2016-2019 Ubiquiti Inc. All rights reserved.

Table of Contents