Power Cord Quick Start Guide (Qty. 2) with Mounting Bracket TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet cable and earth grounding must be used as conditions of product warranty. TOUGHCable ™ is designed for outdoor installations. It is the customer’s responsibility to follow local country regulations, including operation within legal frequency channels, output power, and Dynamic Frequency Selection (DFS) requirements.
Page 8
Long Flash (3:1 on/off cycle) Initializing airFiber Software When the airFiber application begins to boot under airOS, the Signal 4 LED goes from solidly on to a 2.5 Hz flash. This continues until the airFiber X radio is fully booted. Ubiquiti Networks, Inc.
• At the installation site, install the airFiber X antenna with the mounted airFiber X radio (see the antenna’s Quick Start Guide for installation instructions). • Secure the ground wire and mount the GPS antenna. • Establish and optimize the RF link. Ubiquiti Networks, Inc.
Page 10
Master and the Slave. c. If needed, change the Channel Bandwidth, (Master) Duty Cycle, Output Power and/or Maximum Modulation Rate settings. 9. Configure the Frequency Settings. The selected Frequency must be the same on both airFiber X radios. Ubiquiti Networks, Inc.
Need help?
Do you have a question about the AF-2X and is the answer not in the manual?
Questions and answers