Sony ZRD-1 Installation Manual page 54

2. Align the display unit.
Alignment in the X direction: Align the marking line as shown in the illustration.
Alignment in the Z direction: Align the end face of the joint coma (BTM) of the display unit to be
Z
3. Inert the two shafts in the direction of the arrow A, then lock them with the hexagon wrench in the
direction of the arrow B.
. Fully rotate the hexagon wrench in the direction of the arrow B as far as it will go.
. Be sure to lock them. Otherwise, the display unit will be tilted or displaced.
2-20 (E)
installed with the end face of the display unit already installed.
X
Hexagon wrench
Display unit to be installed
Marking line
End face of joint coma (BTM)
End face of display unit already installed
Display unit already installed
Shaft
B
A
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200