Cleaning And Care - Maxwell MW-2112 BK Manual Instruction

Hide thumbs Also See for MW-2112 BK:

Manual instruction (33 pages)

Table Of Contents

Table of Contents

Available languages

ENGLISH

Attachment combs

The length of hair depends on the attach-

ment comb:

• Attachment comb (6): hair length 3 mm

• Attachment comb (7): hair length 6 mm

• Attachment comb (8): hair length 9 mm

• Attachment comb (9): hair length 12 mm

Set the attachment upper part on the station-

ary blade and press it until the lock clicking. To

remove the attachment comb press the clamp

and remove the attachment.

Step one

Set the 3 mm attachment comb (6) or 6 mm

attachment comb (7). Switch the unit on using

the power switch (1), setting it to position «I».

Hold the unit with the blades pointed upwards.

Start haircutting from the beginning of the hair

growth. Slowly move the clipper upwards. This

way cut the head back area at neck bottom

and near the ears (pic. 1, 2, 3)

Step two

Switch the unit off using the power switch (1) by

setting it to the "O" position, unplug the unit, then

set the 9 mm attachment comb (8) or the 12 mm

attachment comb (9) for longer hair and con-

tinue cutting hair near the top of the head (pic.4).

Step three – cutting temples

Switch the hair clipper off and unplug it, then set

the 3 mm attachment comb (6) or 6 mm attach-

ment comb (7) and cut hair in the area of the

temples. Then set the 9 mm attachment comb

(8) or the 12 mm attachment comb (9) and

continue cutting towards the top of the head.

Step four – cutting the top of the head

Using the 9 mm attachment comb (8) or the

12 mm attachment comb (9), cut the hair on

the top of the head towards the crown against

the hair growth direction.

• You can cut hair against and along the

direction of hair growth, but keep in mind

that the hair cut against the growth will be

shorter than the hair cut along the growth.

• Use the 3 mm attachment comb (6) and

6 mm attachment comb (7) for very short

haircut. To leave longer hair, use either the

MW-2112.indd 12

9 mm attachment comb (8) or the 12 mm

attachment comb (9).

• To leave longer hair, take hair locks

between your fingers and cut the hair with

the clipper (pic. 5).

• You can use the comb: lift the hair locks

and cut them above the comb (pic. 6).

• Always start cutting from the back of the

head.

• Set the hair with the comb to reveal uneven

locks.

• Use the scissors to make haircut even

Step five – the final part

– In the final stage of hair cutting, remove the

attachment comb from the hair clipper, turn

the blades of the clipper towards the hair and

trim hair on the temples and neck carefully.

Do not press the clipper strongly, there is

danger of injuries or cuts when open blades

come in contact with the skin (pic. 7).

Cone-shaped haircut

Set the necessary attachment comb and

start cutting from the head back towards

the crown. Cut hair against hair growth from

the head front to the crown and on the head

sides (pic. 8). To get a flat top haircut, use the

comb (11): lift the locks and cut them along

the comb. Set the hair with the comb (11) to

reveal uneven locks.

Note: Between operations, you can hang

the clipper on the hanging loop (5) having

preliminarily switched the unit off using the

power switch (1).