Table of Contents
Advertisement
Simrad EK15
Important
Your computer may be provided with two Ethernet boards to interface with a local area
network (LAN). You must then use one Ethernet board to communicate with the EK15
transceiver(s), and one to communicate with the LAN. These two boards can and must
be set up separately. The Ethernet board used to communicate with the transceivers(s)
must be set up with manual IP addresses. The board used to communicate with the LAN
must be set up to obtain an IP address automatically (unless otherwise decided by your
network administrator.)
Procedure
1
On the computer, define the network adapter settings.
®
Windows
7
Click
a
Start →Control Panel →Network Connections
b
Click
Change adapter settings
c
Click once on the network adapter to select it, and click
short-cut menu.
d
On the list of connections, click
.
Properties
Click
e
Use the following IP address
IP Address:
Subnet mask:
f
Click
to save the settings.
OK
Exit all dialog boxes.
g
On the computer, start the EK15 program.
2
Set up the transceiver(s) and transducer(s).
3
4
Start normal operation.
Related topics
• Installing frequency channels on page 290
• Starting normal operation on page 292
Installing frequency channels
Purpose
This procedure explains how to install a frequency channel.
Description
Each EK15 transceiver with its transducer and (single) frequency is referred to as a
frequency channel.
290
on the left menu.
Internet Protocol 4 (TCP/IPv4)
, and enter the IP address and network mask.
157.237.14.60
255.255.255.0
.
on the
Properties
, and then
351718/C
Advertisement
Table of Contents
