Yale MPC080-VG Service Manual page 19

General
1. DRIVE UNIT COMPARTMENT COVER
2. RETAINING CLIPS
3. GRIP SLOT
4. FRAME
Figure 2. Drive Unit Compartment Cover for Unit
Codes A287, A292, B890 and B896
1. DRIVE UNIT COMPARTMENT COVER
2. RETAINING CLIPS
3. GRIP SLOT
4. FRAME
Figure 3. Drive Unit Compartment Cover for Unit
Codes B287, B292 and C896
2
To install the drive unit cover, make sure the floor mat
is pulled away from the drive unit and place the
bottom of the drive unit cover onto the operator
platform and position the lower edges partially into the
lower retaining clips. Push the top of the cover
partially into the upper retaining clips. Do not push
either edge of the cover in completely in before
starting all edges into the proper place. When the
cover is aligned and started properly, press the cover
completely into the retaining clips and place the floor
mat into the operator platform around the cover.
MPC060/080-F and MTR005/007-F
The drive unit compartment is concealed behind a
contoured, front cover which fits securely around the
drive unit and steer support to the frame. A lower
cover fits around the base of the drive unit platform
and is secured in place with three screws after the
front cover has been installed.
To remove the covers, first remove the three screws
securing the lower cover and remove the lower cover
from the lift truck. Next, reach under the side of the
front cover, near the bottom, and find the grip slot.
With both hands, pull up and away from the truck until
the bottom of the cover kicks out from the retaining
clips. Repeat this for the other side of the cover. Work
around the edge of the cover until free from the truck.
See Figure 4.
To install the covers, place the bottom of the front
cover onto the operator platform and position the
lower edges partially into the lower retaining clips.
Push the top of the cover partially into the upper
retaining clips. Do not push either edge of the cover in
completely before starting all edges into the proper
place. When the cover is aligned and started properly,
press the cover completely into the retaining clips.
Position the lower cover around the base of the front
cover as removed. Make sure the spring nut clips and
the lower cover mounting holes are aligned. Install the
three screws to secure the lower cover in place.
0620 YRM 1283