Painting Instructions; Label Replacement - Yale MPC080-VG Service Manual

0100 YRM 1580
DO NOT make repairs or adjustments unless you
have been properly trained and authorized to do
so. Improper repairs and adjustments can create
dangerous operating conditions. DO NOT operate
a lift truck that needs repairs. Report the need for
repairs to your supervisor immediately. If repair is
necessary, turn the key switch to the OFF posi-
tion, disconnect the battery connector, and attach
a DO NOT OPERATE tag to the control handle.
In some cases a main frame weldment or a fork frame
weldment may be damaged, while the rest of the truck
is still usable. The two frames may be separated from
each other.
WARNING
Always use solvents and paints in an area with
ventilation. DO NOT use solvents or paints near
heat or fire.
Cleaning solvents can be flammable and toxic and
can cause skin irritation. Wear protection for eyes
and skin. When using cleaning solvents, always
follow the recommendations of the manufacturer.
1. Remove all dirt from the surface to be painted.
Clean the area to be painted using a solvent for
painted surfaces. Remove all oil and grease.
WARNING
Replace damaged WARNING or CAUTION labels
immediately.
If labels or information plates are missing or dam-
aged, they must be replaced. See Figure 3.
NOTE: The nameplate is installed using rivets. Re-
move old rivets before installing a new nameplate.
®
See your Yale lift truck dealer to make sure the
nameplate information is correct and complete before
installing a new nameplate. Fasten the nameplate
with the rivet heads outside.
The main frame weldment is connected to the fork
frame weldment by the lift cylinder, upper links, and
rocker arms. Disconnect/connect these components
to separate/assemble the frames.
See the section Lifting Mechanism 4000YRM1589.
Refer to Upper Link - Remove/Install, and Rocker Arm
- Remove/Install.
See
1900YRM1629. Refer to Lift Cylinder - Remove/
Install.

Painting Instructions

2. Remove the top surface of paint and all rust from
3. Protect all surfaces that will not be painted. DO
4. Paint all the surfaces the original color, using

Label Replacement

1. Make sure the surface is dry and has no oil or
2. Remove the paper from the back of the label. DO
NOTE: The label cannot be moved after it touches
the surface.
3. Carefully hold the label in the correct position
the section Walkie
the metal using sandpaper. Paint all metal surfa-
ces where the paint is completely removed using
primer. Apply the primer before applying the color
paint.
NOT paint cylinder rods, cables, labels, plates, or
controls.
®
Yale paint. Follow the directions on the con-
tainer.
grease. DO NOT use solvent on new paint. Clean
the surface of old paint using a cleaning solvent.
NOT touch the adhesive surface.
above the surface. Put the label in the correct po-
sition on the surface. Make sure all air is removed
from under the label and the corners and edges
are tight.
Painting Instructions
Hydraulic System
5