Weslo Pursuit CT 5.9 User Manual page 8

All manuals and user guides at all-guides.com
5. Tip: Avoid pinching the Wire Harness (40)
5
Wire Tie
during this step.
Have another person hold the Upright (4) and
the Top Shield (14) near the Frame (1). Locate
40
the wire tie in the Upright and the Wire Harness
54
(40) in the Frame.
54
See the inset drawing. Tie the lower end of the
14
wire tie to one of the connectors on the Wire
Harness (40). Next, pull the other end of the
54
wire tie upward until the Wire Harness is routed 4
completely through the Upright (4). Then, dis-
40
Wire Tie
card the wire tie.
1
Slide the Upright (4) onto the Frame (1). Attach
the Upright with four M10 x 20mm Patch Screws
(54). Then, press the Top Shield (14) downward
Avoid
into the Frame.
pinching
the Wire
Harness (40)
6. Attach the Handlebar (28) to the Upright (4)
6
with four M6 x 30mm Patch Screws (56).
28
4
56
56
8