Table of Contents
Advertisement
• Verify the knob is in zero
• Verify that the rectangle driver (cylinder) aligned with the knob's rectangle bore.
If required, turn the rectangle driver (cylinder)
below).
Driver
• Assemble the cylinder into the door unit (baseplate & knob).
• Tighten the cylinder's
Note: Verify that the cylinder and the knob are
engaged. Press the knob and turn. If the knob can not
be pressed or turned, disassemble the cylinder, adjust
the cylinder's
• Connect the data cable plug.
• Assemble electrical unit as illustrated.
• Tighten the electrical unit's panel screw.
8
Knob marks point upwards (see page 6).
Knob back view
screw.
rectangle and reassemble.
it is in the same
Knob back view
Data cable
ENTR™ User Manual
(see
screw
1
2
Advertisement
Table of Contents
