Table of Contents
Advertisement
•
the magnet on the front panel of the door frame, as close as possible to
the lock.
• The top point of the magnet should be approximately 20mm below the M5 screw
(see
• Use the supplied double-sided
Note: The magnet area on door frame should be clean and free from dust, peeling
paint etc. If required use alcohol to clean. Wait
Note: Follow the
• Insert the
• Take the key out.
Note: Verify that the gear is not pressed in.
ENTR™ User Manual
only if the cylinder was dismantled from the door unit.
key into the external side of the cylinder and turn one full turn.
to adhere magnet.
completely dry prior to
Door frame
Cylinder
Magnet
Gear not pressed in
screw (M5)
7
Advertisement
Table of Contents
