HIKVISION 5030 User Manual page 41

a.
"Enable": It refers to the enabled state of TIP, and you can choose "yes/no". If you select
"yes", the TIP is ON and at the same time, the information area on the application software
interface also displays: "TIP: ON"; if you select "no", the TIP is OFF and at the same time, the
information area on the application software interface also displays: "TIP: OFF". In addition,
only in the condition of "TIP: ON", the settings below are valid.
b. "Insertion interval": It refers to that how many parcels one dangerous product is inserted per.
The range is the value of multiples of 5: 5-100, and the insertion is random.
c."Floating Range": It refers to the floating range of the insertion position for the TIP pic. and
can be set to the value of multiples of 5 by 0% ~100% .
d. "Time to Recognise when Keep Moving": It refers to the time from the appearance to
disappearance of the TIP pic. in the case of insert the TIP pic. while the scanning images are
moving(i.e., you can recognise the TIP pic in this period of time). During this period, if the
tester or the user presses the functional shortcut- " Recognise TIP" (a functional shortcut can be
set to "Identify TIP" on the system setting, as shown in Section 6.6), then the interface will pop
up the prompt: "Has Recognise TIPxxx"; if no action is applied to " Recognise TIP" shortcut in
this period, the interface will pop up the prompt:" Fail to Recognise TIPxxx", as shown in the
settings above.
When TIP pic. are inserted, you can press " Recognise TIP" functional shortcut within 4
seconds, then the interface will pop up the prompt: "Has Recognise TIPxxx"; if no action is
applied to " Recognise TIP" shortcut within 4 seconds, the interface will pop up the prompt:"
Fail to Recognise TIPxxx". 4 seconds later, the TIP pic. will disappear automatically, and it can
reappear only in the training mode.
e. "Time to Recognise when Keep Still": It refers to the time from the appearance to
disappearance of the TIP pic. in the case of insert the TIP pic. while the scanning images are
static. The principle and process are as the same with moving state.
Record
Record the process related to the TIP insertion and list "Operator", "Begin Time", "Finish Time",
"Injection, "Recog. Count", "Recog. Ratio" and other information, and then export the related
information through the "Export" button on the lower left corner.
Fig 6.22 TIP Principle
- 33 -
Chapter 6 Menu Operation