HIKVISION 5030 User Manual page 13

Chapter 3 Equipment Appearance and Special Keyboard
High Penetrating Power button: It is used to enable/disable the high penetrating power
image processing function. Click it once to enable the function. After entering the system menu, you
can input "9 / w, x, y, z/W, X, Y, Z", as shown in the menu button.
Sign Alarm button: Under the condition of full screen image, when you press this button, the
parts of the image which are impenetrable are displayed in purple red. When you press it again, the
image will change from the marked state to the normal state.
Z789 Suspicious Organics Enhancement button: It used to enable, switch and disable 7/8/9.
Click it once to enable the function, and click it again to disable the function.
"Optimal Screen" button: Under the condition of full screen image, when the image is
zoomed in or move left and right, you can press the "Optimal Screen" button to restore the image
with the magnification of 1.0 and be relatively centered state.
Function Switch: It is not enabled.
Zoom In/Out button: This button is used to zoom in or zoom out the image (with
the rate of 1~64), with the magnification indicated at the bottom of the screen and the constructed
drawing for the amplified image indicated on the lower right corner. When zooming in image, the
current full screen image area is marked out by a red box and you can move and display the image
amplified zone through the direction keys.
Variable Absorption Rate button: It is used to adjust the image variable absorption
rate. After pressing
button to enter the system menu, please input "7/p, q, r, s/P, Q, R, S", as shown in the
pressing
menu button.
7. Function keys:
Energy-saving button: When the system is in the ready state, the upper left of the screen will
pop up the corresponding prompt: Energy-saving mode is enabled by pressing this button. When
the energy-saving sensor is covered by the luggage, the system will start to scan normally, and the
display will indicate the current inspected image. If the energy-saving sensor module fails to detect
there are goods sorting within 15 seconds, the conveyor will stop running automatically in order
to avoid the conveyor idler
saving. When you press this button again under the condition of the system in the ready state, the
upper left of the screen will pop up the corresponding prompt: Energy-saving mode is disabled! At
the moment, the system will return to the normal state. After entering the system menu, please inlet
"5 or j, k, l, or J, K, L", as shown in the menu button.
★ NOTE:
The energy saving function is non-standard configuration, if you want to use this energy
saving function, the equipment should be equipped with the energy-saving sensor module.
button to enter the system menu, please input "6 / m, n, o/M, N, O"; after
running without package so as to achieve the purpose of the energy
- 7 -