HIKVISION 5030 User Manual page 12

1. Key switch
and simultaneously is designed to prevent the non-operators from operating the equipment.
Rotate this switch clockwise to the "ON" state to switch on the power supply of the equipment
control system and rotate it counterclockwise to the "OFF" state to turn the power OFF, exit the
software, shut down the industrial control computer and disconnect the system power supply.
★ NOTE:
The key can be pulled out only in the "OFF" position.
2. Start button
the system is powered on and begins to start up, and at the same time the power indicator light is
on.
3. Status indicator lights
state of the keyboard, and consists of the power indicator light, the indicator light for the
communication between the keyboard and the host and swiping card indicator light from top to
bottom.
4. X-ray indicator light
5. Emergency Stop button
on the equipment stop immediately.
6. Image Processing buttons:
Color Image/BW button: It is used to switch between Color and B/W image modes. When
you click it, the system enters the black and white image display mode; when you click it again, the
system switches to the color display mode so as to realize the switchover of Color Image/BW mode.
After entering the system menu, you can input "1", as shown in the menu button.
Organics Sieving button: It is used to enable/disable the organics sieving image function.
Click it once to enable the organics sieving image processing function, and click it again to disable
the function. After entering the system menu, you can input "2 or a, b, c or A, B, C", as shown in the
menu button.
Inorganic Sieving button: It is used to enable/disable the inorganics sieving image function.
Click it once to enable the inorganics sieving image processing function, and click it again to disable
the function. After entering the system menu, you can input "3 or d, e, f or D, E, F", as shown in the
menu button.
Invert button: It is used to enable/disable the image invert state. Click it once to enable the
image invert function, and click it again to disable the function. After entering the system menu, you
can input "4/g, h, i/G, H, I ", as shown in the menu button.
Super Enhancement button: It is used to enable/disable the image super enhancement
function. Click it once to enable the function, and click it again to disable the function. After
entering the system menu, you can input "8 / t, u, v/T, U, V", as shown in the menu button.
Chapter 3 Equipment Appearance and Special Keyboard
: It is used to switch on the power supply of the equipment control system
: When a key switch is in the "ON" position and the "Start" button is pressed,
: After the system is powered on, it is used to indicate the working
X-RAY
: It says that the X-ray is being emitted.
: When this button is pressed, the X-ray generator and conveyor
- 6 -