Warnings - Graco E-Flo EC1140 Instructions-Parts List Manual

Warnings

Warnings Warnings Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific
risks. When these symbols appear in the body of this manual or on warning labels, refer back to these
Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout
the body of this manual where applicable.
FIRE AND FIRE FIRE AND EXPLOSION AND
Flammable fumes, such as solvent and paint fumes, in work
or solvent flowing through the equipment can cause static sparking. To help prevent fire and
explosion:
• Use equipment only in well ventilated area.
• Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and
plastic drop cloths (potential static sparking).
• Ground all equipment in the work area. See Grounding
• Never spray or flush solvent at high pressure.
• Keep work area free of debris, including solvent, rags and gasoline.
• Do not plug or unplug power cords, or turn power or light switches on or off when flammable
fumes are present.
• Use only grounded hoses.
• Hold gun firmly to side of grounded pail when triggering into pail. Do not use pail liners unless
they are anti-static or conductive.
Stop operation operation immediately
• Stop Stop operation
equipment until you identify and correct the problem.
• Keep a working fire extinguisher in the work area.
Static charge may build up on plastic parts during cleaning and could discharge and ignite
flammable vapors. To help prevent fire and explosion:
• Clean plastic parts only in well ventilated area.
• Do not clean with a dry cloth.
• Do not operate electrostatic guns in equipment work area.
ELECTRIC SHOCK
ELECTRIC ELECTRIC
This equipment must be grounded. Improper grounding, setup, or usage of the system can
cause electric shock.
• Turn off and disconnect power at main switch before disconnecting any cables and before
servicing or installing equipment.
• Connect only to grounded power source.
• All electrical wiring must be done by a qualified electrician and comply with all local codes
and regulations.
4
All manuals and user guides at all-guides.com
WARNING
WARNING WARNING
EXPLOSION HAZARD EXPLOSION HAZARD HAZARD
immediately if static sparking occurs or you feel a shock. . . Do not use
immediately
SHOCK HAZARD HAZARD
SHOCK HAZARD
work area work area can ignite or explode. Paint area
Grounding instructions.
Grounding
3A3384B