Page 2
This documentation only covers products manufactured by KBL AG. It must not be duplicated, photocopied, trans- lated or stored without prior special consent by KBL AG. Duplication on electronic media or in a machine-readable form, either in whole or in part, is also prohibited.
Setting the timer function of the deco lighting ..31 Setting date and time ........... 32 Entering PIN II ............32 O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
This manual describes units equipped with the maximum number of features. Keep this manual ready to hand at all times. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Overturning load! Danger of being crushed by heavy parts of the equipment. • Wear safety shoes. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
X0.L3 Wago item Nr.: 2016-402 X4.3 X2.3 KBL item Nr.: 3200453520 X8.1 F1.D X1.8 jumper settings O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Wiring on the audio system of the studio remote start T-MAX BOX Figure 13.2 CHANNEL BCD CODING T-MAX CONNECTOR PANEL Figure 13.3 O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Aroma box (inlet) Aroma box (outlets) ① Connector (liquid-level monitoring) Inlet (aquaCool medium) aquaCool compressed-air supply O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
UV radiation of sunlight or UV appliances can result in premature ageing of the skin and in a higher risk O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Back to previous/forward to next display Volume aquaCool: on/off/empty Facial Tanner/Shoulder Tanner on/off Body fan O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
After the time given by the timer has elapsed, the session is terminated automatically, and the fan will run on for three minutes. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Page 20
If the system is running short of aquaCool liq- uid, the message “Aqua low” is displayed between O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Page 21
Switching over is done by pressing the “+” or “–” buttons above the channel-selection symbol. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
This message is displayed as a result of: excessive temperature inside the tanning unit, or defective exhaust air fan. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
If there is an error message pending, eliminate the fault fi rst and then reset the message by pressing the “Stop” button. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
entering PIN II PIN II menu level PIN II PIN I (ACC) O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Page 28
(studio music) PULS push START STOP save your choice. PIN 1 (operation info) O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Page 29
START querying software VERSION VERSION STOP information STOP PIN II (Easy Care) O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Page 30
STOP For further Informations STOP STOP please contact the service. Pin II (functions On/Off C'M'A'B') O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
9 (minus button). 4. Save the settings with START and exit the menu by pressing the STOP button. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
4. Activate the function by pressing 4 (plus button) the operating hours of the tubes. or deactivate it by pressing 9 (minus button). O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Level III is exclusively reserved for trained easyCare 2. Select by pressing 5 (plus button) or service staff! O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
(5). Then remove the pane in an upward movement toward the front (6). After cleaning the assembly is carried out in reverse order. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
After the installation, the small glass pin in the middle of the light bulb must point toward the refl ector. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Dirty heat exchangers substantially reduce the performance of the air-conditioning unit. Vacuum-clean them if necessary. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Check the spring ropes for wear. Should individual rope wires have spliced, always replace both ropes. Remove the side pane. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Figure 48.3: Cold air for the canopy (assembly picture) Figure 48.4: Ambient air for the canopy O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Suffi cient airing and ventilation of the exceed the installation level by more than 25 cm. tanning studio must be ensured. O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Bus Relais Replace the AquaCool Relay board (contact your AquaCool Relay board defective. Error Customer Service). O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
11950W with air conditioning: 13150W without air conditioning: 10690W without air conditioning: 11890W power O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
KBL STANDARD WARRANTY KBL warrants your tanning unit to be free of structural defects in its material and workmanship, under normal use, for its rated lifetime. KBL will repair or replace, at their discretion, any defect to the structure which affects the performance of the unit.
Page 58
Remarks O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Page 59
Remarks O p e r a t i n g I n s t r u c t i o n s | KBL 5800...
Need help?
Do you have a question about the 5800 and is the answer not in the manual?
Questions and answers