Axis P1455-LE-3 User Manual page 14

AXIS P1455–LE-3 License Plate Verifier Kit
Vehicle entry and exit scenario
5. Go to the Settings > Access control
6. Go to Type and select Relay in the drop-down list.
7. In the I/O output drop-down list, select the I/O port that is connected to the barrier.
8. In the Barrier mode drop-down list, select open to allowlisted.
9. In the Vehicle direction drop-down list, select in.
10. In the ROI drop-down list, select the region of interest that covers the traffic lane.
11. Enter the following information:
- the IP address for the relay module in format 192.168.0.0
- the username for the relay module
- the password for the relay module
12. To make sure the connection works, click Connect.
13. To activate the connection, click Turn on integration.
14. Go to the List management tab
15. Enter the license plate number in the Allowlist field.
Note
The physical input ports 1 to 8 on the relay module correspond to ports 1 to 8 in the drop-down list. However, the relay ports
1 to 8 on the relay module correspond to ports 9 to 16 in the drop-down list. This is valid even if the relay module only
has 8 ports.
16. Check that the application identifies the license plate number in the allowlist as a known vehicle and that the barrier
opens as expected.
Open a barrier for known vehicles using the camera's I/O
This example explains how to set up AXIS License Plate Verifier together with the camera's I/O port to open a barrier for a known
vehicle entering, for example, a parking area.
Requirements:
• Camera physically installed and connected to the network.
• AXIS License Plate Verifier up and running on the camera.
• Cables connected between the barrier and the camera's I/O port.
• Basic setup done. See .
To watch this video, go to the web version of this document.
www.axis.com/products/online-manual/70394#t10124267
14