Advertisement
Check building codes/permitting. Consult your local Building Department before installation of your pool and equipment.
Pool/equipment installation must comply with the codes of the authority having jurisdiction and may require permits (e.g.,
building, plumbing, electrical, zoning, etc.).
Use for intended purpose only
• Use only as a swimming pool ladder.
• This ladder is designed and manufactured for a specific pool wall height and/or deck of the pool - check product
specification and the height of your pool.
Check that you have all required parts. Check the contents of the carton with the Parts List for this ladder. All parts and
hardware are required. If any parts are missing, DO NOT attempt to assemble or install the ladder. Instead, call Toll
Free U.S. - 800-635-3213 or visit our web site at www.conferladders.com for assistance.
Select an appropriate location - The ladder must be located on a level, solid base and in a location that will be in full view
of competent adult supervision when in use.
Follow all instructions
• For stable, correct assembly and installation, all instructions must be followed completely and in the sequence shown.
• Follow the manufacturer's recommendations for the safe use of all hand tools and equipment used during installation.
Cordless drill only - no corded drills near pool. Use a cordless drill for assembly and installation. To reduce the risk of
electrocution, NEVER use a corded drill in or around a pool.
Lift safely. When lifting awkward or heavy loads, have another person help you.
Double check after installation
• Before using the product, after assembly and installation, go over the instructions and procedures again to make sure
nothing has been overlooked.
• Make sure that safety labels are installed and legible.
CONFER PLASTICS, INC. POOL ENTRY SYSTEM FOR ABOVE-GROUND POOLS
Adjusts to fit most above-ground pools with flat or slightly dished bottoms
Parts List - Single Unit
Code#
Qty.
Description
1
2
Side Panel
7
2
Anti-Entrapment Panel
Threaded Height Adjuster
8
4
(Factory Installed)
2
5
Step w/4 wedges
3
4
Riser
4
1
Kickplate
5
1
Deck Connector
6
2
Base
Hardware Pak - Single Unit
Qty.
Description
3
1/4 - 20 Hex Nut
3
1/4 - 20 X 1" Screw
3
#10 x 1-1/4" Self Tapping Screw
2
Large Plug/Side Panels
1
Label for Top Riser
2
Threaded Cap
2
Red Plug
1
Instructions
2
Safe Installation
To reduce the risk of electrocution, drowning, entrapment, falls, or other serious injury
or death:
Assembly Instructions
Bill of Materials
CTN#
2
2
2
1
1
1
1
1
CTN#
1
1
1
1
1
1
1
1
SECOND PERSON TO ASSIST
Tools Needed For Assembly
• Mallet
• Phillips Screwdriver
• Cordless Drill
• 1/8" Drill Bit
• Level
• Hacksaw
• Knife
• Tape Measure
FASTENING
FLANGE
RISER
RECESS
RISER
GROOVE
Advertisement
