Network/Com - FrontRow ICR-01 Installer's Manual

6. Network / COM
Network Configuration
Automatic IP Configuration (DHCP) Use this setting to have this device request an IP address from a DHCP server; this
should be enabled only if the IT department has a DHCP server online and has set up static (fixed) IP address reservations
for FrontRow devices; otherwise manually enter the IP address reserved for the device in the IP Address field. It is highly
recommended that static IP addresses be used.
IP Address The field displays and also enables entering (changing) the IP address for the device; while the default address is
192.168.1.103. You must use the address provided by the IT department and ensure that each device has a unique address.
IP Subnet Mask Provided by the IT department; if used as part of a Conductor system, the subnet mask must be
255.255.255.0.
Router IP Address Required when this device is in a network in which router switches determine connectivity across subnets.
Provided by the IT department.
Primary NameServer IP Address Optionally provided by the IT department. Rarely used with this device, only enter an IP
address here if specifically requested by the IT department.
Secondary NameServer IP Optionally provided by the IT department. Only enter an IP address here if specifically requested
by the IT department.
Network ports (CNAP, HICP) Under rare conditions, it may be necessary to change the network communication ports used
by other devices and software to communicate with this device. If a such a change is necessary, please direct your browser to
the /cfg/advanced.htm page for this device and refer to the help there.
Serial Port Configuration
Baud Rate Specifies the data speed at which this device should communicate with the attached serial device; while 9600 and
19200 are typical for projectors, data speeds vary by manufacturer.
Stop Bits Specified by the manufacturer of the connected serial device, but is typically 1.
Parity Specified by the manufacturer but is typically None.
11