Table of Contents
Advertisement
414 Wheels and tyres
On-board computer:
Service
Tyres
4
5
Swipe downwards on Touch Control on the
#
left-hand side of the steering wheel.
The
Use current tyre pressures as new refer-
ence values?
message is shown in the multi‐
function display.
To restart, press Touch Control on the left-
#
hand side of the steering wheel.
The
Tyre press. monitor restarted
shown in the multifunction display.
Current warning messages are deleted and
the yellow h warning lamp goes out.
After you have been driving for a few
minutes, the system checks whether the cur‐
rent tyre pressures are within the specified
range. The current tyre pressures are then
accepted as reference values and monitored.
Be sure to also pay attention to the following
related topic:
Notes on tyre pressure (
page 411)
/
R
Wheel change
Notes on selecting, fitting and replacing
tyres
* NOTE Mercedes-AMG vehicles
Observe the notes in the Supplement.
#
You could otherwise fail to recognise
dangers.
message is
& WARNING Risk of accident due to incor‐
rect dimensions of wheels and tyres
If wheels and tyres of the wrong size are
used, the wheel brakes or wheel suspension
components may become damaged.
Always replace wheels and tyres with
#
those that fulfil the specifications of the
original part.
When replacing wheels, make sure to fit the
correct:
Designation
R
Type
R
Internal use only
When replacing tyres, make sure to fit the
correct:
Designation
R
Manufacturer
R
Type
R
& WARNING Risk of injury through exceed‐
ing the specified tyre load-bearing capa‐
city or the permissible speed rating
Exceeding the load-bearing capacity of the
tyres can lead to tyre damage and could
cause the tyres to explode.
Therefore, only use tyre types and sizes
#
approved for your vehicle model.
Observe the tyre load-bearing capacity
#
rating and speed rating required for
your vehicle.
Advertisement
Table of Contents
