Table of Contents
Advertisement
392 Breakdown assistance
1
Tyre sealant bottle
2
Tyre inflation compressor
Depending on the model, the TIREFIT kit may
also be located in other places under the boot
floor.
%
Depending on the power category (LK), the
tyre inflation compressor weighs as follows:
LK1 – 12 V/10 A, 120 W, 0.8 kg
R
LK2 – 12 V/15 A, 180 W, 0.9 kg
R
You can find information on the power cate‐
gory (LK) and/or electrical data on the back
of the tyre inflation compressor.
The tyre inflation compressor is mainte‐
nance-free. If there is a malfunction, please
contact a qualified specialist workshop.
Using the TIREFIT kit
Requirements:
Tyre sealant bottle
R
TIREFIT sticker
R
Tyre inflation compressor
R
Gloves (depending on the vehicle equipment)
R
TIREFIT kit storage location: (
/
You can use TIREFIT tyre sealant to seal perfora‐
tion damage of up to 4 mm, particularly those in
the tyre contact surface. You can use TIREFIT in
outside temperatures down to -20 °C.
& WARNING Risk of accident when using
tyre sealant
The tyre sealant may be unable to seal the
tyre properly, especially in the following
cases:
Internal use only
there are cuts or punctures in the tyre
R
larger than damage previously men‐
tioned.
the wheel rim is damaged.
R
you have driven at very low tyre pres‐
R
sures or on a flat tyre.
Do not drive on.
#
Consult a qualified specialist workshop.
#
& WARNING Risk of injury and poisoning
from tyre sealant
page 391)
Tyre sealant is hazardous to health and cau‐
ses irritation. Do not allow it to come into
contact with your skin, eyes or clothing, and
do not swallow it. Do not inhale any vapours.
Keep the tyre sealant away from children.
Observe the following if you come into con‐
tact with the tyre sealant:
Rinse off the tyre sealant from your skin
#
using water immediately.
Advertisement
Table of Contents
