Table of Contents
Advertisement
1
Low beam
2
High beam
3
Turn signal lights
Turn the relevant housing cover
#
clockwise and remove it.
Low beam / high beam: turn the socket
#
anti-clockwise and remove it.
Indicator: turn the socket anti-clockwise,
#
release it and remove it.
Pull the bulb out of the socket.
#
Insert the new bulb into the socket such that
#
the entire base of the bulb is resting on the
bottom of the socket.
Insert the socket and turn it clockwise.
#
Press on the housing cover and turn it clock‐
#
wise.
Turn signal lights: install the cover in the
#
front wheel arch.
Changing the rear bulbs (vehicles with halo‐
gen headlamps)
Opening and closing the side trim panels in
the boot
1–3
anti-
To open: release right-hand or left-hand side
#
trim panels
To close: reinsert side trim panel 1.
#
Internal use only
1
at the top and remove.
Light and sight 137
Replacing the tail lamp bulbs
Requirements:
The lighting system is switched off.
The side trim panel in the boot is open.
Turn signal lights:
A PY 21 W light bulb is available.
R
Reversing lights:
A W 16 W light bulb is available.
R
Advertisement
Table of Contents
