Fill the Base
Fill the Base
Required Parts:
• SAND/GARDEN HOSE
A
FILL THE BASE
1. Roll the primary sub-assembly to
the desired location for use.
2. Fill the base with water (approx.
36 gallons (136 Liters)) or sand
(approx. 400 lbs. (181 kg)).
3. Insert the cap (28) into the base
to close.
As base is being filled, you may monitor the fill status and proceed with Assemble the Extension Arm, Assemble the
Backboard, and Assemble the Rim sections. DO NOT proceed with Assemble the Upright section until base is completely
filled.
• FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
• THE CAP MUST BE TIGHTENED COMPLETELY AND SECURELY TO PREVENT LEAKAGE.
• CONTACT CUSTOMER SERVICE IMMEDIATELY IF THE CAP IS MISSING OR DAMAGED.
• CHECK THE WATER LEVEL BEFORE EACH USE.
Completed Base Assembly:
NOTE
WARNING
8
#1
#28
Need help?
Do you have a question about the SPA0366 and is the answer not in the manual?