Kaiser K113-4BJCI Assembly Instructions Manual page 10

Gas connections
WARNING! Be aware of flashback!
Make sure there is no debris, spiders, small insects or webs inside the head of the gas cylinder, pressure regulator, burner(s), burner tube(s) or hose,
before any connection is made. They can obstruct the gas flow, which could result in a fire in and around the burner tube. This kind of fire is known as
"flashback" and can cause serious damages. Check and clean (→ CLEANING, MAINTENANCE AND REPAIR) all the parts of the appliance before
assembling it, to reduce the chance of its occurrence.
Mounting / dismounting the gas cylinder
WARNING!
The instructions in this chapter apply for one 11 kg gas cylinder only! Do not attempt to mount any other gas cylinder types inside the gas cylinder
compartment of the appliance!
GB
1. Open the door of the gas cylinder compartment.
2. Place the gas cylinder inside the hole of bottom panel of the compartment.
3. Follow the above steps in reversed order to dismount the gas cylinder.
Connecting / exchanging gas cylinders
WARNING!
Only use the provided or equivalent pressure regulator (→ TECHNICAL DATA) in order to guarantee that it functions safely and efficiently.
Using an improper or a defective pressure regulator is dangerous. Consult your specialised dealer concerning suitable pressure regulators.
The type of the pressure regulator to be used must indicate that it complies with the relevant standard and requirement (EN 16129).
Consult your local gas retailer regarding suitable gas cylinders and pressure regulators (→ TECHNICAL DATA).
NOTE: Gas connections are equipped with left handed threads; the screw-nut needs to be turned counter clockwise!
1. Ensure that there are no ignition sources such as cigarettes, open flames, sparks and other heat sources nearby when connecting or replacing the gas
cylinders.
2. Mount the gas cylinder inside the appliance (→ Mounting / dismounting the gas cylinder).
3. Make sure that all control knobs on the appliance are in the off positions OFF "•".
4. Make sure that the gas valve of the gas cylinder or the gas regulator is closed.
5. Connect the gas hose to the gas line(s) of the appliance. Do not overtighten the connections. Use only the delivered hardware to secure the connections. Do
not use sealing tape or a liquid sealant.
6. Connect the / each pressure regulator to the gas cylinder inlet(s) by turning the pressure regulator counter clockwise. Secure the connection(s) with the
retention nut(s).
7. Connect the other end of the gas hose to the pressure regulator.
8. Check all connections for gas leaks (→ Testing for gas leaks).
Testing for gas leaks
WARNING! Risk of explosion!
Never check for gas leaks using a match or any other open flame.
Test all connections, fittings and all gas hoses for gas leaks every time prior to use of the appliance or each time the gas cylinder is changed. Make sure this
procedure is carried out in a well ventilated area away from flames, sparks or any heat sources. Do not attempt to light the appliance if you smell gas.
1. Make sure that all control knobs on the appliance are in the off positions OFF.
2. Open the gas valve of the gas cylinder or the pressure regulator.
3. Apply leak detector spray or half water / half soap solution with a brush to all the connection points.
4. Turn the gas supply on the valve of the gas cylinder and or the pressure regulator off immediately, if you spot gas bubbles forming on the interested areas.
Tighten all connections again and repeat the test.
5. Do not use the appliance but contact your retailer, if gas bubbles keep forming.
Install Regulator Hose
Do not use the grill until all connections have been checked and do not leak.
Install Gas Tank & Regulator Hose
10