Contents Your dishwasher ........Once the program has finished ....Welcome to our growing ASKO family! ..How to get the best drying results ....Important safety instructions ....Unloading the dishwasher ......General ............Program chart ..........Child safety ..........
"Welcome to your new ASKO. This is a first time set up." is shown on the display the first time the dishwasher is switched on. It is important that you choose the right settings to ensure good...
Important safety instructions SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE WARNING! When using your dishwasher, follow basic precautions, including the following: • Read all instructions before using the dishwasher. • Use the dishwasher only for its intended function. • Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children.
Important safety instructions Child safety • Always keep small children away from the machine when it is open. There may be some detergent residue left inside the machine. • Always close the door and start the dishwasher as soon as you put in the detergent. •...
Page 6
Important safety instructions Contact your municipality for information about where and how your dishwasher can be recycled correctly.
Open the door and press the main power switch. "Welcome to your new ASKO. This is a first time set up." is shown on the display. It is important that you choose the right settings to ensure good dishwashing results.
Page 8
Before washing for the first time Table continued from last page Add rinse aid 1. Open the rinse aid compartment lid. 2. Carefully top up with rinse aid to the level marked max. 3. Wipe up any spilled rinse aid around the compartment. 4.
Greener dishwashing The dishwasher saves energy and water When using a dishwasher in a residential setting, less energy and water are generally used compared to washing the dishes by hand. Do not rinse under running water Do not rinse the dishes under running water as this will lead to increased energy and water consump- tion.
Loading the dishwasher Fragile dishes Some cookware is not dishwasher safe. This can be for several reasons. Some materials cannot withstand high temperatures, others can be damaged by dishwasher detergent. Use caution with, for example, handmade items, fragile decoration, crystal/glassware, silver, copper, tin, aluminum, wood, and plastic.
Loading the dishwasher Top cutlery tray The top cutlery tray accommodates cutlery, ladles, whisks, and other utensils. Raising the top cutlery tray 1. Pull out the top cutlery tray. 2. Pull the two locking handles forward on each side to raise the top cutlery tray. Lowering the top cutlery tray 1.
Loading the dishwasher Lower basket Place plates, side plates, serving dishes, pots, and cutlery (in the cutlery basket) in the lower basket. Place pots and pans in the right rear of the lower basket for the best cleaning results from the two rear spray nozzles (WideSpray ), which are intended for these types of dishes.
Loading the dishwasher Foldable tines Lower the foldable tines when washing large pots. Release the foldable tines by pressing the catch inward before adjusting their position. Washing large plates Move adjustable tines and their mounts to widen the distance between the tine rows to adapt the lower basket to plates with a diameter greater than 9 3/4"...
Loading the dishwasher Fold-down section for small items The cutlery basket has a fold-down section in the middle for small items, or small shafts, such as electric whisk attachments. Typical load Recommended for daily, regular, or typical use. Upper basket...
Using the dishwasher Add detergent Press to open 1. Prewash detergent compartment 2. Main wash detergent compartment Detergent is added according to water hardness. Follow the instructions on the detergent packaging. Too much detergent can result in less effective dishwashing and also entails greater environmental impact.
Using the dishwasher Open the door and press the main power switch. Starting the dishwasher Select program Select program mode Select any options The main power switch Open the door and press the main power switch. Also turn on the water supply valve if it is turned off.
Using the dishwasher Sanitize This program is recommended for baby bottles and cutting boards when additional sanitation is re- quired. The temperature is high in the main wash and in the final rinse. Crystal A gentle dishwashing program with a low temperature for washing fragile items made of crystal/glass, such as crystal glass from Orrefors.
Using the dishwasher Delayed Start When you select Delayed Start, the dishwasher will start 1-24 hours after you have pressed the button Start/Stop and closed the door. 1. Press the button once to activate Delayed Start. Press the button several times – or hold it in – to set the desired number of hours.
Using the dishwasher Once the program has finished The end of the program is indicated by one short signal from the buzzer. The chapter Settings de- scribes how to change this function. The dishwasher switches off automatically after the program ends. To minimize the risk of leaks, we recommend that you turn off the water supply valve if away from home for an extended period of time.
Settings Open the dishwasher's Settings menu To open the dishwasher's Settings menu, press the Navigation button until Settings menu is shown on the display and confirm your selection with the mode selector To exit the dishwasher's Settings menu, select Exit and confirm your selection with the mode selector Navigation buttons for choosing setting Mode selector to confirm current setting Setting...
Page 23
Settings Table continued from last page Settings Options Display settings Contrast top dis- For adjusting the contrast of the display. play1/2/3/4 Logo in top display On/Off Setting to hide the logo shown on the dis- play. Feedback sound 0/1/2/3 This sound is used to confirm each button press.
Care and maintenance instructions Add rinse aid When the rinse aid needs topping up, the above symbol lights on the display. Press to open 1. Open the rinse aid compartment lid. 2. Carefully top up with rinse aid to the level marked max. 3.
Care and maintenance instructions Fine filter 1. Turn the locking ring counterclockwise and lift the fine filter straight up. 2. Clean the fine filter. 3. Refit the fine filter and turn the locking ring clockwise to its stop position. Check that the edges seal properly.
Care and maintenance instructions Top spray arm • Remove the upper basket then release the top spray arm. See section Upper spray arm. • Pull out the top cutlery tray. Push the top spray arm up and turn the spray arm bearings counter- clockwise to remove the spray arm.
Care and maintenance instructions If you have hard water, limescale deposits may build up in the dishwasher. If this happens, run the Self-cleaning program with two tablespoons of citric acid in the detergent compartment (with no dishes in the machine). Special dishwasher cleaners are also available in stores. ®...
Troubleshooting Type of fault on the display Action Overfilling water 1 Clear the drain pump. See the chapter Care and maintenance instructions. If the problem persists, call the Customer Care Center. Water outlet fault See “Water remains in the dishwasher above the filters” in the table “Problem”...
Page 29
Troubleshooting Table continued from last page Problem Possible causes Action The dishwasher does not start. The Start/Stop start button has Press and hold Start/Stop until been pressed for too short a the display shows "Program time. started, close door in 4 sec". The door is not closed properly Close the door within four sec- or was not closed immediately...
Page 30
Troubleshooting Table continued from last page Problem Possible causes Action The dishes are not clean. The spray arms do not rotate. Check that the dishes are not blocking the spray arms. Spray arm holes or bearings Clean the spray arms. See the blocked.
Page 31
Troubleshooting Table continued from last page Problem Possible causes Action Spots or films on the dishes. Incorrect rinse aid dosage set- See the chapter Settings. ting. Too high temperature and/or too Wash crystal at a low tempera- much detergent can cause ture and with a conservative etching on crystal.
Page 32
Troubleshooting Table continued from last page Problem Possible causes Action Water remains in the dishwasher The filters are blocked. Clean the coarse and fine filters. above the filters. The filters are not fitted correctly. Check that the filter handle is locked in the stop position.
Page 33
Troubleshooting Table continued from last page Problem Possible causes Action The dishes are not dry enough. Depending on the load, the pro- Activate the Extra Dry option. gram's drying cycle may be in- sufficient. The dishwasher is not fully load- Fully load the dishwasher.
Installation instructions [''] *Remove lock nuts for an installed height of 32 3/4'' . If a height of 32 1/4''is required for ADA compliance, remove the upper trim kit. Also lower the trim kit on the sides. **If European widths of 23 5/8'' (600 mm) is required, remove the trim kit. Nominal dimensions.
Installation instructions Transport protection for the door Do not forget to remove the transport protection for the door when unpacking the dishwasher. Trim kit The dishwasher is equipped with a trim kit to fit the 24'' cutout standard. If a European width of 23 5/8'' (600 mm) is required, remove the trim kit.
Installation instructions Placing the dishwasher The dishwasher is intended to be built in under a countertop. The built-in measurements are shown in the illustration. Make sure that the cord and hose hole's edges are even and will not damage the drain and inlet hoses or the power cord.
Installation instructions NOTE! The surface to which the protective film is fitted must be clean and dry. Adjust the height and slide the dishwasher into place 1. Start by measuring the height from the floor to the bottom edge of the countertop. 2.
Installation instructions 7. Make any final adjustments to the feet (the dishwasher may lean no more than 1/4'') and tighten the lock nuts on the front feet. Drain connection This dishwasher is suitable for installing in a raised recess (to attain an ergonomic working height). This means that the dishwasher can be placed so that the drain hose runs to a lower level than the bottom of the dishwasher, such as by routing it directly to a floor drain.
Installation instructions Max. 37 3/8'' The drain hose can also be connected to a connection nipple on the sink unit's water trap. The connection nipple must have an internal diameter of at least 1/2''. The drain hose may be extended by a maximum of 87" (2.2 m) (the total length of the drain hose must not exceed 177"...
Installation instructions NOTE! Do not exceed the permitted water supply temperature. Certain materials used in some cookware cannot withstand strong heat. See Fragile dishes in the chapter Loading the dishwasher. Electrical connection Information about the electrical connection can be found on the serial number plate. This specification must match the electricity supply.
Page 41
Installation instructions Screw the dishwasher into place with two extra screws If there is an air gap of more than 1/8'' between the underside of the countertop and the top edge of the dishwasher, the dishwasher ought to be screwed into place with two extra screws.
Installation instructions Dishwasher toe kick The dishwasher is supplied with a toe kick. Fit the sound insulation (only certain models) Fit the toe kick Ensure the floor underneath the toe kick is at same height as the floor underneath the dishwasher.
2. Service calls to correct the installation of the ASKO Product, to instruct you on how to use the ASKO Product, to replace or repair house fuses, or to correct house wiring or plumbing.
OTHER THAN ACTUAL DAMAGES AND IN NO EVENT FOR DAMAGES IN EXCESS OF THE PRICE PAID FOR THE ASKO PRODUCT AS TO WHICH A CLAIM IS MADE. Some jurisdictions do not allow the exclusion or limitation of incidental, consequential or other damages, so these limitations and exclusions may not apply to you.
Technical information Technical data Height: 32 3/4 - 34 7/8" Width: 24" Depth: 22" Weight: 100 lb (45 kg) Water pressure: 4.2–140 psi Electrical connection: See serial number plate Rated power: See serial number plate If a height of 32 1/4'' is required for ADA compliance, remove the upper trim kit. Also lower the trim kit on the sides.
Page 46
Customer Care Center: 1-800-898-1879 | www.askona.com 842845 We reserve the right to make changes.
Need help?
Do you have a question about the DBI663IS.U and is the answer not in the manual?
Questions and answers