Table of Contents
Advertisement
Capillary installation:
Please follow the steps described below for capillary installation:
Note:
The unit is adjusted with testing capillary and at spectral light maximum (about
214 – 240 nm) shall be 100 % value of energy with new lamp.
Note:
This unit does not include test cell, cell nor accessories of cell.
B
ELOW ARE STATED ONLY DIFFERENCES FROM BASIC TECHNICAL PARAMETERS OF THE UNIT
Parameter
Noise (Test capillary, 254 nm, TC 2 s, 10 Hz)
Drift (Test capillary, 254 nm)
P/N
Qty
23984000
1
EKAB-011
1
Value
B
ASIC ACCESSORIES
Picture
Description
Tube fuse T - 2.5A/250V, CSA
Mains cable 10A-250V 1.5 m
41 / 47
ECD2800 / ECD2600
Turn off the lamp!!!
Open the door on unit front
panel. Loosen the screw on
black box and move it to left,
as shown on the pictures.
Open
capillary in slot as you can see
on the picture on right. Cleaned
part
should be centered. In the
door center is a photodiode.
Do not touch it with bare
hands!
Close the box, move the screw
back and tighten it. Now the
capillary is fixed at correct
place.
± 10·10
-6
AU
1·10
-4
AU/hr.
the
box
and
install
(window)
of
capillary
.
Advertisement
Table of Contents
