Advertisement
26. Take one end of the rope and thread up through the lowest
pulley on the wood frame. Continue threading the rope up
through the upper, inner pulley on the riser block and pull
toward the carriage. See Figure N.
Figure N
27.Thread the rope through the pulley attached to the black
Tri-Loop with pulley on the same side of the Reformer as the
riser and pull back toward the riser.
28. Thread the rope through the upper, outer pulley on the riser
block and pull back toward the carriage. See Figure O. See
Figure O
IMPORTANT SAFETY NOTE: Use of the Konnector system in a manner for which it is not intended may result in equipment damage
and/or injury to the user. Intense cardio work utilizing jarring movements may overload the system. Balanced Body is not responsible
for injuries caused by equipment misuse.
Questions? Call Balanced Body Technical Support at 1-800-PILATES (US and Canada), or +1-916-388-2838 (all other countries).
WARNING: Using the existing shoulder posts with a Konnector system can cause the loops to fall off the posts during use which
may cause serious injury.
Figure P for a detailed view of the riser pulley block rope
routing.
Figure P
29. Using a Soft-Touch connection, see Figure Q, secure each
end of the rope to a grey Tri-Loop on the same side of the
Reformer as the riser.
Figure Q
30 . Repeat steps 27-29 for the other side of the Reformer.
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | info@pilates.com
400-441 | 03.22.19
Advertisement
