Table of Contents
Advertisement
Rewinder XLP 51x
User Manual
Setting up
FITTING THE REWINDER
The rewinder is attached to the front of the printer with two screws. A support leg absorbs some of the
strain exerted by the material roll.
Before you begin
Tools:
• Hex srewdriver, 3 and 4 mm
Prerequisites:
Place the printer on a level surface. Ensure that there is enough room in front of the printer for the sup-
port leg of the rewinder.
About this task
Procedure
1. Remove the cover (A) of the mounting flange. To do this, turn out the two screws (B).
Edition 2b - 9/2021
7
Setting up
Fitting the rewinder
Advertisement
Table of Contents
