Table of Contents
Advertisement
Rewinder XLP 51x
User Manual
ACTIVATING/DEACTIVATING THE REWINDER
Before you begin
The rewinder is ready fit and connected. The printer is switched on.
About this task
After fitting it to the printer, the rewinder has to be activated. This is done by setting the appropriate
parameter in the parameter menu of the printer.
Procedure
Activating the rewinder:
1. Set
Options
Afterwards,
2. Select the desired rotating direction
The printer restarts. Afterwards, the following has changed:
– An additional submenu
rection
that is required to set the rotation direction of the rewinder.
– The icon
started again (alternates with icon
Deactivating the rewinder:
3. Set
Options
Edition 2b - 9/2021
>
Selection
>
Periph. device
Don´t confuse with the setting
Options
>
Rewinder
>
Rewind direction
Default setting =
Printing outside
Options
>
is visible above key 3. By pressing this key, the rewinder can be stopped and
After the restart of the printer starts the rewinder to rotate. If no label material is inserted, an er-
ror warning will follow, because the printer control assumpts torn-off material.
► Acknowledge the error message.
After acknowledging the error message, the rewinder can be startet/stopped by pressing key 3.
>
Selection
>
Periph. device
to Rewinder.
Intern. rewinder
that activates the internal rewinder of the printer.
is called automatically.
(Printing inside
or
Printing
Rewinder
appeared, which contains the parameter
).
to None.
10
outside).
Activating/deactivating the rewinder
Rewind di-
Setting up
Advertisement
Table of Contents
