Troubleshooting; Cleaning - Novexx Solutions XLP 51 Series User Manual

Rewinder XLP 51x
User Manual

TROUBLESHOOTING

Printer stopps rewinder
If the printer stopps for some reason, the rewinder stopps too.
► Eliminate the cause of the stopp (if it was unintended).
Rewinder stopps printer
If the dancer arm stays during rewinder operation in the loose position for some seconds (approx. 5),
the following error message shows up:
Status num:5004
Rew. mat. tear
The printer control assumpts that the material is torn off between printer and rewinder.
Printer and rewinder are stopped.
► Insert material newly and acknowledge the error message.
Narrow label material is pulled to the inside edge
When narrow label material is used (< 30 mm), problems with the material guiding between printer and
rewinder may occur. In this case, the label material is pulled to the inside edge underneath the print
head and crumples there.
► Install the run-in roller for narrow labels.
EXPERTS
For detailed information refer to the service manual, topic section „Attachment, Setup, Service",
chapter „Run-in roller for narrow labels".

CLEANING

► Remove dust particles with a soft brush or a vacuum cleaner.
► Clean the housing with a cloth moistened with a standard commercial neutral cleaner.
► Remove glue residues with a cloth moistened with ethyl alcohol.
Edition 2b - 9/2021
WARNING!
Rotating shaft!
Danger of hair and clothing being pulled in by unintentional actuation of the rewinder.
► Switch off the printer and disconnect the power cable before cleaning the unwinder.
15 Operation / Malfunction / Cleaning
Troubleshooting