Table of Contents
Advertisement
Rewinder XLP 51x
User Manual
5. Adjust the material guides (A) on the dancer arm by pushing them sideways until they correspond
to the width of the material.
STARTING/STOPPING
Before you begin
Printer is switched on and is showing the "Home" screen.
Procedure
Starting:
1.
Press key 3 (
The rewinder starts rewinding, until the dancer arm reaches the final position. At that point, the
rewinder stops.
2. Press key 1 to get to the "Ready" screen.
Stopping:
3.
To stop or start again, press key 3 (
Edition 2b - 9/2021
The material should run evenly, and there should be a small gap between it and the material
guides.
).
It is essential to let the dancer arm initially reach its final position after starting. Only then, the
dancer arm takes control over the rotation speed.
If a printjob has already been loaded, both printing and rewinding start nearly simultaneously.
14
, works on both screens, "Ready" and "Home").
Operation / Malfunction / Cleaning
Starting/Stopping
Advertisement
Table of Contents
