Table of Contents
Advertisement
Rewinder XLP 51x
User Manual
TECHNICAL DATA
Motor
Position sampling
Rotation direction
Rewind speed
Noise level
Material roll
SYSTEM REQUIREMENTS
Rewinders in the appropriate width can be operated at the following printer types:
Printer
XLP 514
XLP 516
Preparation for peripheral devices:
For using the printers with a rewinder, they must be especially equipped. This so called peripherals
preparation consists mainly of an additional output stage board for the motor of the peripheral device
and of some additional connection cables. From the outside, the peripheral preparation can be identi-
fied by the D-Sub connector (A) on the front side of the printer:
A
Fig. 3: The D-Sub connector (A) is an indicator for the peripheral preparation of the printer.
Edition 2b - 9/2021
Stepper motor
Hall sensor
Rewind direction with label facing outside or inside
XLP 51x: Max. 254 mm/s (10 Inch/s)
< 70dB(A)
See table:
Max. outer Ø
Core inner Ø
Min. material width
Max. material width
Max. roll weight
Width
Core Ø
38 mm (1.5")
120 mm
76 mm (3")
38 mm (1.5")
185 mm
76 mm (3")
230 mm
38/76 mm (1,5/3")
= Minimal print width
= Width of the rewinding mandrel (120/185 mm)
5 kg
Article number
N103130
N103131
N103137
N103138
6
Product description
Technical data
Advertisement
Table of Contents
