Table of Contents
Advertisement
Quick Links
INSTALLATION MANUAL
Level of Difficulty
Easy
Wiring Location(s)
T3 and T5
Wiring Location Guide*
for Trucks (T)
T1 Behind driver side taillight housing
T2 Behind passenger side taillight housing
T3 Behind driver side rear bumper
T4
Behind center of rear bumper fascia
T5 Behind passenger side rear bumper
T1
T2
T3
T4
T5
* Representative vehicle shown
Tools Required
Drill
Flathead screwdriver
Drill bit, 3/32"
Cutting tool
58967-INS-RB
•
PAGE 1
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
Product Photo
Included Parts
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
Maintenance
Periodic inspection of all wires and connections should be performed
to ensure there is no visible damage or loose connections.
Product Registration and Warranty
CURT Group stands behind our products with industry-leading warranties.
Provide feedback and help us to improve our products by registering your purchase at:
warranty.curtgroup.com/surveys
Advertisement
Table of Contents
Related Manuals for curt CM-58967
Summary of Contents for curt CM-58967
- Page 1 Periodic inspection of all wires and connections should be performed to ensure there is no visible damage or loose connections. Product Registration and Warranty CURT Group stands behind our products with industry-leading warranties. Provide feedback and help us to improve our products by registering your purchase at: warranty.curtgroup.com/surveys 58967-INS-RB •...
- Page 2 Step 1 Locate the vehicle battery. Look up the battery location in the owner's manual of your vehicle. Disconnect the negative battery terminal. Be sure to fasten this wire down and away from the battery when completing the installation process. Step 2 Locate the electrical junction box at the rear of the vehicle between the frame rail...
- Page 3 Step 5 Route the 4-flat harness above the junction block between the frame and the bed of the truck. Continue along the driver-side frame rail to the front of the truck. Step 6 Route the 4-flat above and along the frame rail to just behind the driver-side front wheel.
- Page 4 Step 9 - How to use fish wire A) Fish wire is a way to push or pull an electrical wire through a blind hole. Make sure the wire is long enough to stick out on the other side. Insert the fish wire through the blind hole and locate it on the other side.
Need help?
Do you have a question about the CM-58967 and is the answer not in the manual?
Questions and answers