Advertisement
02. Precautions for equipment design
02-1. Precautions for mechanical design
1) Position of connectors on a board
(1)
When using board to board connectors, a pair of board shall NOT be connected
with multiple connectors. Otherwise, misaligned connector positions may cause
mating failure or product breakage.
Panasonic corporation does not guarantee the failures caused by using the multiple
connectors.
(2)Solid board is tend to warp to vertical direction against mill direction of
production process. Some warp directions can cause poor soldering. Therefore,
arrange the board in a direction that can minimize warp.
Tendency to warp easily to
production direction (horizontal direction)
Panasonic Corporation
industrial.panasonic.com/ac/e/
Operation manual for Narrow-pitch connectors P5KF
This gap causes poor
soldering.
- 3 -
It is possible to prevent poor soldering
by the arrangement of mounting
connector on the horizontal direction.
×
©
Panasonic Corporation 2017
ACCTF1E-4 201704
Advertisement
