Advertisement
03-6. Detailed precautions for manual soldering
(1) General precautions
- When applying flux, apply it thinly on each foot
pattern using a brush pen as shown on the
previous page.
(Place the connector at a predetermined
position after applying flux.)
- The use of a soldering iron with a retractable-
knife shape tip as shown in the previous page is
also recommended.
- While heating with the soldering iron, it is
recommended to slide the iron tip on the foot
pattern along the terminals without touching them.
- Apply the soldering iron to the foot pattern
to heat it. Complete soldering in 1 or 2 seconds.
Connector's resistance to soldering heat
- Thin wire solder with a diameter of
- Final soldering is recommended after provisionally soldering the terminals at
both ends.
- Note that when the soldering iron touches the terminal, wicking or contact
failure may occur.
(2)Detailed precautions on how to apply the iron tip
Apply the iron tip to the end of the
foot pattern trace to heat and melt solder.
Do not press down on the terminals with the iron
tip, otherwise, the contact may be deformed.
Do not press forward on the terminal tip with
the iron tip, otherwise, the contact may be
deformed.
Panasonic Corporation
industrial.panasonic.com/ac/e/
- 300 °C: 5 sec max., - 350 °C: 3 sec max.
Operation manual for Narrow-pitch connectors P5KF
0.3 - 0.4 mm
Soldering
iron tip
©
- 17 -
Panasonic Corporation 2017
Move the iron tip in
this direction.
The extended trace length should be long
enough so that the iron tip does not touch the
leads.
is recommended.
Solder wire
ACCTF1E-4 201704
Advertisement
