Before Using The Appliance - Frigidaire PCFD3668AF Use & Care Manual

14

BEFORE USING THE APPLIANCE

First power on
Preliminary setup
When setting the clock or a timer, depending on
how you turn the knob, you can set a different
increase / decrease speed for the settable minutes.
• Turn and release: minutes increase / decrease
one by one.
Example: 00:00 > 00:01 > 00:02 > 00:03 > etc.
• Hold turn: minutes increase / decrease one by
one for the first 3 minutes, then the timer
switches directly to the nearest multiple of 15,
increasing or decreasing in 15 minute steps.
Example: 00:00 > 00:01 > 00:02 > 00:03 > 00:15 >
00:30 > 00:45 > 01:00 > 01:15 > etc.
When setting the minutes you will only see the
icon. Once 60 minutes have been exceeded
the icon will also appear.
Blackout management
After a blackout, there can be two scenarios
depending on how long the appliance has been
without power.
1. A few seconds to a few minutes: the appli-
ance restores the settings and features set
before the power loss event.
2. A few minutes to hours: The appliance does
not save the previous settings and will have
to be reprogrammed.
First power on
When the range is first plugged in, or when the
power supply has been interrupted "12:00 PM" will
flash on the timer display.
It will stop flashing once the current time is set up
as below.
Setting the display clock
1. Press the oven temperature knob to enable
the time selection.
2. The hours can be set by turning the
temperature knob towards the right or left.
Press the knob to confirm the selection.
3. Repeat the same process for setting the
minutes. Press the knob to confirm the
selection.
Once the time has been set, the display switches to
standby mode where only the current time is
shown.
To adjust the display clock after the initial set up, in
the stand-by mode, just hold turn the temperature
knob left or right for at least 3 seconds, until you
see the hour digits flashing.
The instructions to adjust the clock in detail are the
same as for setting the clock in the case of the first
power on (see "Setting the display clock") starting
from point no. 2.