HP MSR2000 Series Manual page 22

To connect the grounding cable:
Remove the two grounding screws from the rear panel of the chassis.
1.
Attach the grounding screw to the ring terminal of the grounding cable. See
2.
Use a Phillips screwdriver to fasten the grounding screw into the grounding screw hole.
3.
Remove the grounding screw from the grounding point on the rack.
4.
Use a needle-nose pliers to bend a hook at the other end of the grounding cable, attach it to the
5.
grounding point, and secure it with a screw. See
Figure 19 Connecting the grounding cable to the grounding hole of the router
Figure 20.
xi
Figure 19.