Installing A Dsic - HP MSR2000 Series Manual

Figure 22 Removing the filler panel
Figure 23 Installing the SIC

Installing a DSIC

CAUTION:
DSIC interface modules are not hot swappable. Make sure the router is powered off before installing a
DSIC.
To install a DSIC:
Remove the screws on the filler panel on a SIC slot of an MSR3024, 3044, or 3064 to remove the
1.
filler panel.
For an MSR3024/3044/3064, a DSIC can be installed after you remove the slot divider between
slot 1 and slot 2, or between slot 3 and slot 4.
Loosen the captive screws on the slot divider and pull out the slot divider.
2.
You can install a DSIC to an MSR3024/3044/3064 after you remove the slot divider.
xv