Adjusting the Positioning the
Primary Charging Roller Cleaning
4
Solenoid
Make adjustments so that the length of the
primary charging roller solenoid (SL1)
indicated in the figure is 4.0 ±0.2 mm.
4.0 ± 0.2mm
Figure 2-17
CHAPTER 2 STANDARDS AND ADJUSTMENTS
D. Pick-Up/Feeding System
Adjusting the Positioning the
1
Multifeeder paper Guide Cam
Make adjustments so that the paper guide
plate cam is as shown when the solenoid plate
is in contact with the claw of the control ring.
Paper guide plate
Paper guide plate
Control ring
Gear 1
Screw w/ hex hole
Claw
Solenoid plate
Gear 2
Figure 2-18
2-11